3 Reasons your Raleigh Homes Energy Bill is High and How to Fix It

3 Reasons your Raleigh Homes Energy Bill is High and How to Fix It ?

A homeowner’s energy bill can amount to hundreds of dollars every month. The average American pays $118 every month for power (over $1,400 every year). Contrary to your home loan/mortgage or homeowners insurance, your energy bill price can vary from month to month. Is more difficult to plan for less pay for, although changes can be handled by changing around some funds or dipping into savings.

What should you do if you open the bill and see that the sum that you’re used to paying has increased ? Stress is the least of the emotions many would believe when getting a massive increase in an energy bill, along with the very first question most would believe is, “How did this happen ?”

3 Reasons your Raleigh Homes Energy Bill is High and How to Fix It

To fix it is the thought of going through a lot of homeowner’s heads. Before assuming something goes wrong with your property, you should go over your invoice, carefully comparing it to invoices from previous months and take weather conditions into account with this — when there was a cold snap, you might require more heat, etc.. Another reason may be that your gas or electric company has increased its rates, and your bill would reflect that.

Explanations aside from huge fluctuations your electricity over-consumption, in personal use or sudden increases from energy businesses, may be due to leaking into these three areas: windows, insulation, and roof.

Request a Free Raleigh Roofing Estimate

It takes about 5 seconds to fill out our contact form, or call, and you can get your estimate about a couple of business days later.

Receive a Personalized Raleigh Roofing Estimate

A personalized call directly with the owner will walk you through your roof replacement estimate in Raleigh.

You Choose What’s Right For You

We’ll create a worry-free roofing experience with you in mind – for your Raleigh roof replacement.

INSULATION

In terms of energy waste, Insulating material has lots of layers. The chief issue of insulation is the installation of this item in the first location. Degrading of this product over time comes second. Below are a few common mistakes home-builders create when installing insulation, which may be the reason your electricity bill is large:

#1. IMPROPER SEALING

A Sealant is a difficulty in installed insulation that is inefficient. Leaking through improperly sealed insulation not only results in the warmth or cool air to escape from the house more quickly through the cracks, but it also can pose substantial issues with moisture and general comfort in the home. Making sure there’s a proper seal on all possible leak sites (doors, windows, plate penetrations, chases, and drywall sealant to high plates) is the best way to ensure your house is airtight and up to code.

#2. POORLY INSTALLED AIR BARRIERS AROUND DOUBLE WALLS AND TUBS/SHOWERS

An Air barrier and constant insulation possibly prevent moisture in addition to air leakage, but only as long as it’s correctly installed. Badly installed barriers are another frequent problem resulting in energy leakage. In some homes at the time of construction, the tub and shower are installed before the insulating material, so certain important elements of the insulation are overlooked.

#3. MISALIGNMENT

The Misalignment of insulation occurs when the insulation itself doesn’t have great contact with the air barrier or other material in contact with the air barrier (example: if house wrap employed to the exterior sheathing, the insulating material should even be touching the sheathing). Simply put, the air barrier and the insulation must always be in contact. If they’re not, the insulating material is askew. Degradation of the insulating material over time is another culprit for Energy leakage, causing bills at the month’s end. Insulation that is un-compromised can last for a long time. House wrapping, wrap tape, and spray on foam methods of insulation can endure up to 80 or even more years if properly installed, and foamboard, cellulose (made from recycled paper), fiberglass, rock wool, and BLOWN-IN INSULATION can last 100 years or more. Even though the time insulation lasts sounds like a very long time, you will find components that can degrade Present insulation, decreasing its longevity:

1) Water damage (caused by roof leaks) may cause the insulation to break down quicker. Water damage may also lead to the production of mold/mildew.

2) Mold, in case it forms, can degrade insulation over time and also make it less effective. Mold can also cause serious health problems to people in the form of respiratory and heart issues. Mold, if found, should be removed promptly by a professional and measures should be taken to prevent mold from forming in the future.

3) Fiberglass/cellulose insulating material has the potential to fall from ceilings, attics, or crawl spaces approximately 15-20 years after placement.

4) Insulation that becomes polluted or mucked up with debris and dust can break down the insulation over time.

5) If you live in an older home, it’s likely there is not sufficient insulation (less was used typically when building homes in the past. Therefore your house might be insufficiently insulated. Regardless Issues with insulation could be the culprit for the Energy bill crisis, so it’s important to get insulation scrutinized by a Professional at least once a year; even if you don’t have high energy bills, They can be forestalled by you with inspections.

WINDOWS

Windows, according to the Department of Energy (DOE), “ are responsible for 25%-30% of residential heating and cooling energy use.” If your windows are not energy efficient or in good condition, the suggestion is to replace or repair existing windows.

For most people, updating is a less-expensive and Not as Enterprise when it comes to windows. Some tips the DOE gives on how to find problem areas and where to make changes are:

1) Assessing windows to air leaks. A suggestion would be to close a dollar in a pub, and if you’re able to pull out the dollar, there are significant air-leak issues.

2) Caulking and adding weather-stripping to windows fix or to prevent leaks. You can do this yourself or employ an expert, but a specialist is suggested.

3) Adding window treatments (blinds, curtains, etc.). Heavy curtains are the most efficient for keeping in heat and cooling, in addition to blocking out the sun, which may overheat a house.

4) Adding storm windows/panels to present windows

5) Adding a solar control film/tint to present windows

6) Adding exterior shade sources (awnings, outdoor blinds, or overhangs)

If you have decided WINDOW REPLACEMENT is Right for you, make sure that you work with a certified or bonded builder that Specializes in this area. A professional will know Just What windows your Home requires, in addition to understanding which type will work best to keep energy efficiency.

ROOFING

There is A roof crucial for ensuring your energy bills remain in your comfort level fiscally. There are a lot of reasons why your electricity bill is large, and it may very well be on top of your house. Here are.

#1. YOUR ROOF IS GETTING TOO HOT.

Occasionally, specific kinds of roofing can get unbelievably hot (like asphalt). A colored asphalt roof system can get up according to the Green Home Guide. Incredibly, the roof’s color may be used. Lighter colors, therefore, consume less heat and signify sunlight more. When a roof becomes too hot, your atmosphere conditioner/HVAC starts working overtime to cool your property. A”cool roof” can choose the temperature down and provide your air conditioner a rest. To apply this idea, you can either paint the roof a lighter color or replace the existing roof with an absorbent material in a light color.

#2. INSULATION IS POORLY INSTALLED.

Insulation is another reason for energy leakage. Improperly roof insulation may require the two more air conditioning in warm weather and more heating. It is important when contemplating insulation for your roof to contemplate the climate you typically take care of daily, depending upon the season. In regards to appropriate insulation for your house, A licensed roofer, such as the professionals in Able Roof, can point you in the perfect direction.

3) UNSUSTAINABLE ROOFING ON YOUR HOME.

Sometimes the roof is insufficient, and it needs replacement to cut down on electricity costs. Even though this may give a person sticker-shock, over time, the investment pays for itself. Able Roof professionals understand what roofing system would best fit your house to augment energy efficiency. With more and more alleged” sustainable” and”green” roofing choices coming on the current market, Competent Roof can direct you toward the very best roofing for your home.

Whether your electricity leaking issues are coming out of your chimney, roof, or insulation difficulties, they need to get solved quickly. There are not any situations where energy bills can be reduced by significantly less electricity consumption aside from repairing leaks and seals when necessary, replacing worn out materials with new, more expensive versions.

If your roof is the culprit, the best people to contact would be the friendly experts at AMI Builders. Most tasks can be finished within one day. An excellent installation can be done in that short a time, building a choice not only the best one but also the fastest. Schedule a consultation or call for 24/7 emergency services today for all your roofing needs.

CALL FOR A FREE ESTIMATE, AND WE’LL COME TO YOU IN THE COMFORT OF YOUR NC HOME.

Leave a comment

1 × four =